Dishwashers · UK, Ireland & Europe

Siemens dishwasher error E10 (E:10)

Your Siemens dishwasher shows E10 or E:10. Siemens treats it as a drying-system fault, not a water problem.

Short answer

Fault in the dishwasher's drying system: contact Siemens service.

What E10 (E:10) means on Siemens

Siemens says E10 means there is a fault in the dishwasher's drying system, and asks owners to contact Siemens Service and quote the code. Siemens and Bosch dishwashers are built by the same group (BSH), and on models with Zeolite drying this is the drying heater.

Safety first. Switch the appliance off at the wall or breaker before you open any panel. Heaters, pumps and control boards run on mains voltage: replacing them is a job for a qualified technician. More safety notes

Step-by-step fix

  1. Switch off and on

    Switch off at the wall or breaker for about 30 seconds, then restart a programme. This clears one-off glitches.

  2. Watch the drying

    If the code does not return and dishes dry normally, no further action is needed.

  3. Contact Siemens ServiceCall a pro

    If E10 returns, Siemens asks you to contact Siemens Service and quote "E10" with your model (E-Nr) from the rating plate on the door edge.

Advertisement

Common causes

  • Fault in the drying system (on Zeolite models, the drying heater circuit)
  • Temporary electronics glitch

How to prevent it

  • Use rinse aid and salt as recommended
  • Do not overload: blocked spray arms make drying harder
  • Leave the door shut until the cycle ends

Tools & parts you may need

  • None for owners: drying-system repairs are a technician job

Related Siemens codes

CodeMeaning (from Siemens)
E07Fault in the drying system
E09 / E11Fault in the heating system
E12Heating element calcified or dirty: descale
E14Water protection triggered (filling or supply)
E15Water in the base tray: turn off the tap
E18Water inlet fault: tap, hose or inlet filter
E22Filters dirty or clogged
E23Waste water pump fault

FAQ

Is Siemens E10 the same as Bosch E10?

Both say it is a drying-system fault. Bosch names the Zeolite (CrystalDry) chamber heater; Siemens just says "drying system".

Where do I find the E-Nr?

On the rating plate on the edge of the door. Quote it with the code when you call service.

Sources

Checked on 26 October 2026. Codes can differ between model generations: your own manual always wins. Spotted an error? See About & corrections.

Advertisement